Hw-module Slot R0 Reload
by admin
Can anyone comment on RSP redundancy with SSO mode?
I have a test 7507 with rsp-k4pv-mz.120-32.S8.bin on both RSP2s. I've done
redundancy
no keepalive-enable
mode sso
And it doesn't seem to ever sync the slave
ranttest#show red
Redundant System Information :
------------------------------
Available system uptime = 14 minutes, 49 seconds
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = hsa
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 2
Current Software state = ACTIVE
Uptime in current state = 13 minutes, 24 seconds
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(32)S8, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Mon 20-Aug-07 16:34 by leccese
BOOT =
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Peer (slot: 3) information is not available because it is in 'DISABLED'
state
ranttest#redundancy force-switchover
Cannot perform switchover until the standby is fully initialized.
The box is up, its got two OSPF adjacencies, maybe a hundred routes - its
not doing anything fancy, so I'm kind of stuck here. The production target
is 7507s /w RSP4s, the same OSPF, and about 180k routes via BGP. Any idea
what might be wrong here?
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
archive at http://puck.nether.net/pipermail/cisco-nsp/
- Hw-module Slot R0 Reloadable
- Hw-module Slot R0 Reloading
- Hw-module Slot R0 Reloaded
- Hw-module Slot R0 Reloader
I have a test 7507 with rsp-k4pv-mz.120-32.S8.bin on both RSP2s. I've done
Hw Module Slot 1 Oversubscription casino players Hw Module Slot 1 Oversubscription will receive a free real cash bonus whenever they play at a casino for real money. Casinos usually give out bonuses in the form of deposit matches usually. Hw-module module. The CLI will only give you the further option of 'shutdown' if the service module supports it eg. An FWSM does support shutdown so you would get the option in the above command. A CSM does not support shutdown so you would only get the option to reload.
this:Hw-module Slot R0 Reloadable
service single-slot-reload-enableredundancy
no keepalive-enable
mode sso
And it doesn't seem to ever sync the slave
ranttest#show red
Redundant System Information :
------------------------------
Available system uptime = 14 minutes, 49 seconds
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = hsa
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 2
Current Software state = ACTIVE
Uptime in current state = 13 minutes, 24 seconds
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(32)S8, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Mon 20-Aug-07 16:34 by leccese
BOOT =
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102 Peer (slot: 3) information is not available because it is in 'DISABLED'
state
ranttest#redundancy force-switchover
Cannot perform switchover until the standby is fully initialized.
The box is up, its got two OSPF adjacencies, maybe a hundred routes - its
not doing anything fancy, so I'm kind of stuck here. The production target
is 7507s /w RSP4s, the same OSPF, and about 180k routes via BGP. Any idea
what might be wrong here?
Hw-module Slot R0 Reloading
_______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net
Hw-module Slot R0 Reloaded
https://puck.nether.net/mailman/listinfo/cisco-nspHw-module Slot R0 Reloader
archive at http://puck.nether.net/pipermail/cisco-nsp/